Driver's Window Motor Test
Driver's Window Motor TestMotor Test:
1. Remove the door panel.
2. Disconnect the 4P connector (A) from the driver's window motor.
3. Test the motor in each direction by connecting battery power and ground according to the table. When the motor stops running, disconnect one lead immediately.
4. If the motor does not run or fails to run smoothly, replace it.
Pulser Test:
1. Reconnect the 4P connector to the driver's window motor, and reconnect the 20P connector to the power window master switch.
2. Connect the test leads of a voltmeter to the No.3 and No.4 terminals of the driver's window motor 4P connector.
3. Run the motor using the master switch. The voltmeter should read about 6 V.
4. If the voltage is not as specified, check for an open in the wires. If the wires are OK, replace the driver's window motor.