Clutch Disc and Pressure Plate Installation
Clutch ReplacementSpecial Tools Required
^ Clutch alignment shaft 07LAF-PT00110
^ Clutch alignment disc 07JAF-PM7011A
^ Remover handle 07936-3710100
^ Ring gear holder 07LAB-PV00100 or 07924-PD20003
^ Attachment, 57 x 40 mm 07746-0010200
^ Driver 077 49-0010000
Clutch Disc and Pressure Plate Installation
1. Install the ring gear holder.
2. Apply super high temp urea grease (P/N 08798-9002) to the splines (A) of the clutch disc (B), then install the clutch disc using the special tools.
3. Install the pressure plate (A) and the mounting bolts (B) finger-tight.
4. Torque the mounting bolts in a crisscross pattern. Tighten the bolts in several steps to prevent warping the diaphragm spring.
5. Remove the special tools.
6. Make sure the diaphragm spring fingers are all the same height.