Flywheel Inspection
Clutch ReplacementSpecial Tools Required
^ Clutch alignment shaft 07LAF-PT00110
^ Clutch alignment disc 07JAF-PM7011A
^ Remover handle 07936-3710100
^ Ring gear holder 07LAB-PV00100 or 07924-PD20003
^ Attachment, 57 x 40 mm 07746-0010200
^ Driver 077 49-0010000
Flywheel Inspection
1. Inspect the ring gear teeth for wear and damage.
2. Inspect the clutch disc mating surface on the flywheel for wear, cracks and burning.
3. Measure the flywheel (A) runout using a dial indicator (B) through at least two full turns with the engine installed. Push against the flywheel each time you turn it to take up the crankshaft thrust washer clearance. If the runout is more than the service limit, replace the flywheel and recheck the runout.
Standard (New): 0.06 mm (0.002 inch) max.
Service Limit: 0.15 mm (0.006 inch)
4. Turn the inner race of the pilot bearing (A) with your finger. The bearing should turn smoothly and quietly. Check that the bearing outer race fits tightly in the flywheel. If the race does not turn smoothly, quietly, or fit tight in the flywheel, replace the bearing.