6. Transmission Range Switch

Transmission Range Switch Installation





1. Set the control lever (A) to the N position by turning it.

NOTE: Do not squeeze the end of the control shaft tips (B) together when turning into position. If the tips are squeezed together it will cause a faulty signal or position due to the play between the control shaft and the switch.





2. Align the cutouts (A) on the rotary-frame with the neutral positioning cutouts (B) on the transmission range switch, then put a 2.0 mm (0.08 inch) feeler gauge blade (C) in the cutouts to hold it in the N position.

NOTE: Be sure to use a 2.0 mm (0.08 inch) blade or equivalent to hold the switch in the N position.





3. Install the transmission range switch (A) gently on the control shaft (B) while holding it in the N position with the 2.0 mm (0.08 inch) blade (C).





4. Tighten the bolts on the transmission range switch while you continue to hold the N position. Do not move the transmission range switch when tightening the bolts. Remove the feeler gauge.





5. Install the transmission range switch shaft cap.