Operation CHARM: Car repair manuals for everyone.

P1879

DTC P1879: Problem in CVT Start Clutch Pressure Control Valve Circuit

NOTE: Record all freeze data and review General Troubleshooting Information before you troubleshoot.

1. Turn the ignition switch OFF.
2. Disconnect the solenoid harness connector (8P).





3. Measure the resistance between solenoid harness connector (8P) terminals No. 4 and No. 8.
Is the resistance 3.8 - 6.8 Ohms ?
YES-Go to step 4.
NO-Replace the lower valve body assembly.
4. Disconnect TCM connector A (26P).





5. Check for continuity between TCM connector terminal A1 and body ground, and between A14 and body ground.
Is there continuity?
YES-Repair short to ground in the wire between TCM connector terminal A1 or A14 and the solenoid harness connector (8P).
NO-Go to step 6.
6. Connect the solenoid harness connector (8P).





7. Measure the resistance between TCM connector terminals A1 and A14.
Is there 3.8 - 6.8 Ohms ?
YES-Check for loose terminal fit in the TCM connectors. If necessary, substitute a known-good TCM and recheck.
NO-Repair open in the wire between TCM connector terminal A1 or A14 and the solenoid harness connector (8P).