Front Door Weatherstrip: Service and Repair
Door Seal and Door Weatherstrip Spacer ReplacementNOTE:
- Take care not to scratch the door.
- Use a clip remover to remove the clips.
1. Remove these items:
- Before removing the door upper seal, remove the door panel and door sash outer trim.
- Before removing the door weatherstrip spacer, remove the door panel.
2. Remove the door upper seal, door still seal, and door weatherstrip spacer as shown.
3. Install the seals and spacer in the reverse order of removal, and note these items:
- Replace any damaged clips.
- If the old upper seal and spacer are to be reinstalled, scrape off all traces of old butyl tapes, EPT sealer, and adhesive tape, then clean the upper seal and spacer surfaces with alcohol. Attach the new butyl tapes, EPT sealer, and adhesive tape to the door upper seal and door weatherstrip spacer.
- Press the butyl tape and adhesive tape portions to make the adhesive stick.
- Check for water leaks.
- Test-drive and check for wind noise.