Dashboard

Dashboard Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.

NOTE:
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Have an assistant help you remove and install the dashboard.
- Take care not to scratch the dashboard, body, and other related parts.
- Put on gloves to protect your hands.

1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the negative cable from the battery, and wait at least 3 minutesbefore beginning work.

3. Remove these items:
- Front console
- Center lower cover
- Audio unit
- Steering column
- Passenger's airbag
- A-pillar trim, both sides




4. Disconnect the steering beam wire harness connectors (A), main wire harness connector (B), floor wire harness connector (C), water temperature sensor connector (D), mode motor connector (E), and air hose (if equipped) (F).
5. Detach all of the harness and connector clips.
6. Remove the driver's pocket (G).




7. Remove the bolts (A) and screws (B), and lift up on the dashboard (C) to release it from the dashboard holders (body side) (D). Take care not to scratch the shift knob, seats, and interior parts.
8. Carefully remove the dashboard through the door opening.
9. Install the dashboard in the reverse order of removal, and note these items:
- Make sure the dashboard fits onto the dashboard holders correctly.
- Before tightening the bolts, make sure the dashboard wire harness and steering beam wire harness are not pinched.
- Make sure the connectors are plugged in properly.
- Reconnect the negative cable to the battery.
- Enter the anti-theft code for the radio, then enter the customer's radio station presets.
- Reset the clock.
- Do the ECM idle learn procedure.