Trim Removal/Installation - Hatch Area
Trim Removal/Installation - Hatch AreaSpecial Tools Required
KTC trim tool set SOJATP2014 *
*Available through the American Honda Tool and Equipment Program
NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to bend or scratch the trim and panels.
1. Remove the trim as shown.
2. Install the trim in the reverse order of removal, and note these items:
- Check for damaged or stress-whitened clips, and replace them with new ones.
- If the old trim is to be reinstalled, scrape off the double-sided adhesive tape, then clean the trim and seal surfaces with alcohol. Attach the new double-sided adhesive tape to the seal, and install the seals to both sides of the trim.
- Before reinstalling the trim, clean the body bonding surface with alcohol.
- Locate the painted alignment mark on the rear window trim. Align the painted mark with the alignment tab in the center of the hatch, and install the trim all the way around facing in the direction shown.
- Make sure the upper rear window defogger connectors are plugged in properly.
- Push the clips into place securely.