Trim Removal/Installation - Rear Quarter Panel Area
Trim Removal/Installation - Rear Quarter Panel AreaSpecial Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to bend or scratch the trim and panels.
- When removing the hatch support strut, you will need to open or close the hatch by hand.
- Remove the quarter trim panel and rear side trim panel as an assembly.
1. Remove these items:
- B-pillar lower trim panel
- Door weatherstrip, as necessary
- Cargo floor mat and rear trim panel, as necessary
- Seat belt upper anchor
- Hatch support strut, body side
2. Remove the trim as shown.
3. Install the trim in the reverse order of removal, and note these items:
- Check for damaged or stress-whitened clips, and replace them with new ones.
- Apply liquid thread lock to the anchor bolt before reinstallation.
- Before installing the anchor bolt, make sure there are no twists or kinks in the seat belt.
- Push the clips into place securely.