Steering Column: Service and Repair

Removal and Installation
SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section before performing repairs or service.

Removal
1. Record the radio station presets, and disconnect the negative cable from the battery.
2. Remove the driver's airbag.
3. Remove the steering wheel.
4. Remove the cable reel.





5. Remove the column covers (A).
6. Remove the combination switch assembly (B) from the steering column shaft by disconnecting the connectors.
7. Disconnect the ignition switch connectors.
8. Disconnect the steering joint (c), and remove it from the column shaft.
9. Remove the steering column (D) by removing the attaching nuts.

Installation
1. Install the steering column, and make sure the wires are not caught or pinched by any parts.





2. Insert the upper end of the steering joint onto the steering shaft (A) (line up the bolt hole (B) with the flat portion (C) on the shaft).
3. Slip the lower end of the steering joint onto the pinion shaft (E) (line up the bolt hole (F) with the groove (G) around the shaft), and loosely install the lower joint bolt. Be sure that the lower joint bolt is securely in the groove in the pinion shaft.
4. Pull on the steering joint to make sure that the steering joint is fully seated. Then install the upper joint bolt and tighten both joint bolts.
5. Finish the installation, and note these items:
- Make sure the wire harness is routed and fastened properly.
- Make sure the connectors are properly connected.
- Reinstall the steering wheel.
- Reconnect the battery cable:
- Do the power window control unit reset procedure.
- Reset the radio station presets.
- Set the clock.
- Verify horn and turn signal switch operation.
- Check wheel alignment.