Reading Diagnostic Trouble Codes
How to Retrieve EPS DTCsHonda PGM tester Method:
1. With the ignition switch OFF, connect the Honda PGM tester (A) to the 16P data link connector (DLC) (B) located under the dash on the passenger's side of the vehicle.
2. Turn the ignition ON (II), and follow the prompts on the Honda PGM tester to display the DTC(s) on the screen. After determining the DTC, refer to the DTC Troubleshooting Index. DTC List - Electrical Power Steering
NOTE: See the Honda PGM tester user's manual for specific instructions.
Service Check Signal Circuit Method:
1. With the ignition switch OFF, connect the Honda PGM tester (A) to the 16P data link connector (DLC) (B) located under the dash on the passenger's side of the vehicle.
2. Short the SCS circuit to body ground using the Honda PGM tester.
3. Turn the ignition switch ON (II).
4. The blinking frequency indicates the DTC. DTCs are indicated by a series of long and short blinks. Add the long and short blinks together to determine the DTC. After determining the DTC, refer to the DTC Troubleshooting Index.
The system will not indicate the DTC unless these conditions are met:
- Set the front wheels in the straight ahead driving position.
- The ignition switch is turned ON (II).
- The engine is stopped.
- The SCS circuit is shorted to body ground before the ignition switch is turned ON (II).
5. Turn the ignition switch OFF.
6. Disconnect the Honda PGM tester from the DLC.