Rear Window Lower Molding/Rear Window Harness Holder

Rear Window Lower Molding/Rear Window Harness Holder Replacement

'02 - 07 Models

NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the top cloth.
- Use seat covers to avoid damaging any surfaces.

1. Lower the convertible top cloth by operating the convertible top.




2. From outside the rear window, remove the molding (A) from the edge of the rear window (B). From inside the rear window, remove the rear window harness holder cover (C) from the rear window harness holder (D), and disconnect the rear window defogger connectors (E). Remove the rear window harness holder from the inside face of the rear window. If necessary, cut the molding with a utility knife.
3. Clean the edge of the rear window with alcohol where new molding and harness holder are to be installed. Make sure the bonding surface is kept free of water, oil, and grease.




4. Apply primer to the areas of the rear window (A) where the molding and harness holder will be attached, and apply primer to the groove of the molding (B) and to the harness holder (C). Be sure the harness holder lines up with the alignment marks (D).
5. Attach the molding and harness holder to the rear window with urethane adhesive.
6. Scrape or wipe the excess adhesive off with a putty knife or towel. To remove adhesive from the rear window, use a soft shop towel dampened with alcohol.