Camshaft Inspection

Camshaft Inspection

NOTE: Do not rotate the camshaft during inspection.

1. Remove the dipstick, Positive Crankcase Ventilation (PCV) hose and breather hose (see step 18).
2. Remove the ignition coil cover, then remove the ignition coils (see step 19).
3. Remove the cylinder head cover (see step 21).
4. Loosen the rocker arm adjusting screws (see step 27).
5. Remove the camshaft holders and camshafts.
6. Insert the bolts into the rocker shaft holder, then remove the rocker arm assembly (see step 29).
7. Disassemble the rocker arm assembly.





8. Put the rocker shaft holders, camshafts and the camshaft holders on the cylinder head, then tighten the bolts to the specified torque.
9. Seat the camshafts by pushing them toward the rear end of the cylinder head.





10. Zero the dial indicator against the end of the camshaft, then push the camshaft back and forth and read the end play. If the end play is beyond the service limit, replace the cylinder head and recheck. If it is still beyond the service limit, replace the camshaft.
11. Unscrew the camshaft holder bolts two turns at a time, in a crisscross pattern. Then remove the camshaft holders and the rocker shaft holders from the cylinder head.
12. Lift the camshafts out of the cylinder head, wipe them clean, then inspect the lift ramps. Replace the camshaft if any lobes are pitted, scored, or excessively worn.
13. Clean the camshaft journal surfaces in the cylinder head, then set the camshafts back in place. Place a plastigage strip across each journal.
14. Install the camshaft holders, then tighten the bolts to the specified torque as shown in step 8.





15. Remove the camshaft holders. Measure the widest portion of plastigage on each journal.
- If the camshaft-to-holder clearance is within limits, go to step 17.
- If the camshaft-to-holder clearance is beyond the service limit and the camshaft has been replaced, replace the cylinder head.
- If the camshaft-to-holder clearance is beyond the service limit and the camshaft has not been replaced, go to step 16.





16. Check the total runout with the camshaft supported on V-blocks.
- If the total runout of the camshaft is within the service limit, replace the cylinder head.
- If the total runout is beyond the service limit, replace the camshaft and recheck the camshaft to-holder oil clearance. If the oil clearance is still out of tolerance, replace the cylinder head.











17. Measure cam lobe height.