Accessory Power Socket Test/Replacement
Accessory Power Socket Test/Replacement1. Remove the rear console.
2. Disconnect the 2P connector.
3. Inspect the connector terminals to be sure they are all making good contact.
- If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
- If the terminals look OK, go to step 4.
4. Turn the ignition switch ACC (I), and check for voltage between the No.1 and No.2 terminals.
- There should be battery voltage.
- If there is no battery voltage, check for:
- blown No.9 (10 A) fuse in the under-dash fuse/relay box.
- faulty accessory power socket relay
- poor ground (G401,G601)
- an open in the wire.
5. Remove the housing and socket.