C1611

DTC C1611 CAN TIME-OUT EMS

COMPONENT LOCATION

Refer to DTC C1235. C1235

GENERAL DESCRIPTION

Refer to DTC C1605. C1605

DTC DESCRIPTION

The HECU checks the CAN communication lines for normal ESC control, and sets this code if a PCM(ECM) message is not received within predefined time.

DTC DETECTING CONDITION:

TERMINAL & CONNECTOR INSPECTION

Refer to DTC C1260. C1260

COMPONENT INSPECTION

1. Ignition "OFF".
2. Ignition "ON".
3. Connect scan tool and select "Diagnostic Trouble Codes (DTCs)" mode.
4. Using a scan tool, Clear DTC.
5. Select "Diagnostic Trouble Codes(DTCs)" mode again.
6. Are any DTCs present?

YES
- Substitute with a known-good PCM(ECM) and check for proper operation. If problem is corrected, replace PCM(ECM) and then go to "Verification Of Vehicle Repair" procedure. If NG, replace HECU and then go to "Verification Of Vehicle Repair" procedure.

NO
- Fault is intermittent caused by faulty HECU or was repaired and HECU memory was not cleared. go to "Verification Of Vehicle Repair" procedure.

VERIFICATION OF VEHICLE REPAIR

Refer to DTC C1101. C1101