Rear Wiper Cover Modification/Floormat Anchor Improvement

SERVICE PROCEDURE: REAR WIPER COVER MODIFICATION





The rear wiper cover prevents the rear wiper from folding outward to allow access for snow removal, rear glass cleaning or wiper blade replacement.





1. Remove cover by spreading the cover on the top and bottom.





2. Remove the tab using pliers to flex the tab forward and backwards.

WARNING:
Use caution to prevent damage to the cover.

3. Trim any excess flash.





4. Reinstall the rear wiper cover and confirm proper operation of the wiper arm.

NOTE:
No parts replacement required.

NOTE:
Do not submit a separate warranty claim for this procedure.

SERVICE PROCEDURE: FLOORMAT ANCHOR IMPROVEMENT

1. Remove Driver's floormat.





2. Mark the floor mat 1-1/2" from the left edge and 1" from the bottom edge.





3. Using a hammer and a 9/16" or 14 mm socket punch a hole through the top side of the floormat at. Trim any excess fabric.





4. Squeeze the upper and lower floor mat grommet halves together in the hole.





5. Place the mat in the vehicle aligned with the production floor anchor. Mark the carpet with a marker.





6. Remove the floormat. Place the new floor anchor over the mark and twist clockwise until the anchor is securely fixed to the carpet.

7. Re-install the floormat and confirm that the mat fits properly and is secure.





8. Secure the floormat with the supplied plastic screw.

NOTE:
Do not submit a separate warranty claim for this procedure.