Interior - Front/Rear Door Trim Panel Paint Peeling
Group: BODYNumber: 07-60-006
Date: AUGUST, 2007
Model:
SANTA FE
Subject
UPPER INTERIOR DOOR TRIM PANEL - PAINT PEELING OFF DURING WRAP GUARD REMOVAL
DESCRIPTION:
Some 2007 Santa Fe's may exhibit a paint peeling condition on the upper door trim panel during removal of the blue protective wrap guard.
NOTE:
If one or more of the door trim panels exhibit this condition, replace the affected door trim panel under normal warranty procedures.
AFFECTED VEHICLES:
Model: 2007 SANTA FE (CM) all trim levels.
Affected vehicle production date range: March 1, 2007 to May 31, 2007
TOOLS REQUIRED
PARTS REQUIRED
NOTE:
Wear white cotton gloves to minimize damage to vehicle and for hand protection.
SERVICE PROCEDURE:
Door Trim Panel Replacement Procedure
1. Remove inside handle cover
2. Remove door trim panel screws (2)
3. Release the clips that hold the door trim panel (7-front door/8-rear door)
4. Disconnect wire harness from door trim panel.
5. Remove door trim panel by lifting upward.
6. If plastic clips are not attached to the door trim panel, then remove from the door inner panel with pliers.
Installation is reverse of removal
NOTE:
Function test when complete, checking for operation of power window switch, fuel filler switch, trunk lid switch and door lamp
WARRANTY INFORMATION:
Normal warranty procedures apply.