Operation CHARM: Car repair manuals for everyone.

P0711

DTC P0711 TRANSAXLE FLUID TEMPERATURE SENSOR RATIONALITY

COMPONENT LOCATION:





GENERAL DESCRIPTION
The automatic TRANSAXLE fluid (ATF) temperature sensor is installed in the Valve Body. This sensor uses a thermistor whose resistance changes according to the temperature changes. The TCM supplies a 5V reference voltage to the sensor, and the output voltage of the sensor changes when the ATF temperature varies. The automatic TRANSAXLE fluid (ATF) temperature provides very important data for the TCM's control of the Torque Converter Clutch, and is also used for many other purposes.

DTC DESCRIPTION
This DTC code is set when the ATF temperature output voltage is not changed for 15 minutes. The TCM regards the ATF temperature as fixed at a value of 80°C (176°F).

DTC DETECTING CONDITION:




SPECIFICATION:




SCHEMATIC DIAGRAM:





MONITOR SCANTOOL DATA
1. Connect Scantool to data link connector (DLC).
2. Engine "ON".
3. Monitor the "OIL TEMPERATURE SENSOR" parameter on the scan tool.





4. Does "OIL TEMPERATURE SENSOR" follow the reference data?
YES
- Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure.
NO
- Go to "Terminal and connector inspection" procedure.

TERMINAL AND CONNECTOR INSPECTION
1. Many malfunctions in the electrical system are caused by poor harness and terminal condition. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?
YES
- Repair as necessary and go to "Verification of vehicle Repair" procedure.
NO
- Go to "Signal circuit inspection" procedure.

SIGNAL CIRCUIT INSPECTION
1. Engine "OFF" IG KEY "OFF".
2. Remove the TCU.
3. Perform the continuity test between ATF sensor terminal and chassis-ground.
Specification: Not continuity
4. Is resistance within specifications?
YES
- Go to "Component inspection" procedure.
NO>
- Check for short to ground in harness. Repair as necessary and Go to "Verification of Vehicle Repair" procedure.

COMPONENT INSPECTION
1. Engine "OFF" IG KEY "OFF".
2. Remove the TCU.
3. Measure the resistance for "TRANSAXLE FLUID TEMPERATURE SENSOR".





4. Is resistance within specifications?
YES
- Substitute with a known-good PCM/TCM and check for proper operation. If the problem is corrected, replace PCM/TCM as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
- Replace "TRANSAXLE FLUID TEMPERATURE SENSOR" as necessary and Go to "Verification of Vehicle Repair" procedure.

NOTE: When replacing the TCU, must perform the N position learning and the Initial learning.

VERIFICATION OF VEHICLE REPAIR
After a repair, it is essential to verify that the fault has been corrected.
1. Connect Scantool and select "Diagnostic Trouble Codes (DTCS)" mode.
2. Using a Scantool, Clear DTC.
3. Operate the vehicle within DTC Enable conditions in General information.
4. Are any DTCs present?
YES
- Go to the applicable troubleshooting procedure.
NO
- System performing to specification at this time.