Campaign - 2nd Row Seat May Not Return Upright
Group: CAMPAIGNNumber: 07-01-009
Date: MAY, 2007
Model:
2007 VERACRUZ
Subject:
2ND ROW CENTER SEAT BELT GARNISH REPLACEMENT (SERVICE CAMPAIGN T42)
IMPORTANT:
DEALERS MUST PERFORM THIS CAMPAIGN ON ALL AFFECTED VEHICLES PRIOR TO CUSTOMER RETAIL DELIVERY AND WHENEVER AN AFFECTED VEHICLE IS IN THE SHOP FOR ANY MAINTENANCE OR REPAIR.
IMPORTANT:
WHEN A VEHICLE ARRIVES AT THE SERVICE DEPARTMENT, ACCESS HYUNDAI MOTOR AMERICA'S "WARRANTY VEHICLE INFORMATION" SCREEN VIA DCS ON-LINE TO IDENTIFY OPEN CAMPAIGNS.
DESCRIPTION:
On some VERACRUZ (EN) vehicles, the 2nd row center seat back may not be returned to the upright position after being folded forward. When folding the 2nd row center seat back, a deformed 2nd row center seat belt garnish may allow the webbing stopper to retract into the seat belt garnish, making it impossible to return the 2nd row center seat back to the upright position.
This bulletin provides the procedure for 2nd row center seat belt garnish replacement.
APPLICABLE VEHICLES:
^ Applicable vehicle production date range:
- Produced from December 22, 2006 to March 13, 2007
PARTS REQUIRED
NOTE:
1. The above two parts are supplied as a kit.
2. Be sure to order the correct color.
SERVICE PROCEDURE:
CAUTION:
Before performing the procedure below, check if the plate has been applied to the seat belt garnish plate by pressing the "A" area (55 mm) by hand. If the plate has been applied, no further procedure is needed.
^ If it has not been installed, replace the 2nd row center seat belt garnish with a new one and add the plate to the seat belt garnish plate.
1. Remove the 2nd seat LH head rest (B).
2. Use your knee to prevent the 2nd row center seat belt webbing from retracting.
NOTE:
If the stopper (c) is allowed to retract into the garnish, unbolt the seat belt to allow the seatback to be raised to the upright position. After the seatback has been raised, reattach the seat belt bolt.
Tightening Torque:
46.6 Nm (4.8 Kgf.m, 34.4 lb-ft)
3. Remove the 2nd row center seat belt garnish (D).
CAUTION:
Be careful not to soil or damage the seat.
4. Disengage the rear of seat the belt garnish (E) from the seat cover opening reinforcement by raising it, and remove the 2nd row center seat belt garnish according to the procedures shown below.
5. Separate the 2nd row center seat belt garnish from the seat belt webbing (I).
6. Fit the plate (J) to the end of seat cover opening reinforcement.
7. Push the plate (K) into the hole, and then fit the plate to the seat cover opening reinforcement (L), pulling it rearward.
8. Install the new 2nd row center seat belt garnish (M).
9. Verify that the 2nd row center folds and raises properly.
CAMPAIGN CLAIM INFORMATION