Turn Signals: Service and Repair

TURN SIGNAL LAMP

REMOVAL
1. Disconnect the negative (-) battery terminal.







2. Loose the screws (2EA) holding the rear combination lamp then disconnect the connector then remove the outside rear combination lamp(A).




3. Replace the bulbs (B) after disconnecting the rear combination lamp assembly (A).




4. Disconnect the lamp cover on tailgate. Remove the lamp assembly after loosening the connector(A), Cap nuts (2EA) and nuts (2EA).




5. Remove the tailgate combination lamp assembly and the replace the bulbs (A).

INSTALLATION
1. Install the trunk combination lamp assembly after assembling the bulb.
2. Install the lamp cover to the trunk after connecting the lamp connector.
3. Install the rear combination lamp assembly after assembling the bulbs after connecting the lamp connector.