A/T - Stall Test Procedure

Veracruz Automatic Transaxle Stall Test Procedure

To diagnose a transaxle for "slipping" or Diagnostic

Trouble Codes P0731 P0732, P0733, P0734, P0735 or P0736 (incorrect gear ratio), perform a stall test using the:

^ A/TTester II, PIN 09450-AT000 (see TSB 00-40-008) or A/T Tester Plus

^ "Stall Test Procedure without A/T Tester":

Stall Test Procedure Without A/T Tester:

1. Check the automatic transaxle fluid level. Add ATF, if necessary, to bring the level within the "HOT" range. Follow TSB 07-40-004.

2. Firmly apply the parking brake and place blocks in front and behind both front wheels.

CAUTION:
Do not let anybody stand in front of or behind the vehicle during the test.

3. Start the engine and move the select lever to "D".

4. Press and hold the brake pedal, then fully depress the accelerator and record the engine speed.

CAUTION:
Do not hold the throttle fully open for more than 5 seconds. Release the throttle and allow the engine to idle in "N" for 5 seconds.





5. Confirm the stall speed is within the specifications





This procedure tests the following clutches and brakes. The C2 clutch can be tested for slipping by driving in 4th 5th and 6th gear:

WARRANTY INFORMATION:

Labor time for the stall test is included in 45000R00 (Replace automatic transaxle).