Reassembly

REASSEMBLY

NOTE:
^ Thoroughly clean all parts to be assembled.
^ Before installing the parts, apply fresh engine oil to all sliding and rotating surfaces.
^ Replace oil seals with new ones.

1. Install valves.
1) Using SST(09222-22001), push in a new valve stem seal with applying engine oil.





NOTE:
^ Do not reuse old valve stem seals.
Incorrect installation of the seal could result in oil leakage past the valve guides.
^ Reassemble the valve stem seals

2) After applying engine oil on the outer surface of each valve stem, insert the valve in the valve guide. Install the valve, valve spring and spring retainer.

NOTE: When installing valve springs, the side coated with enamel should face toward the valve spring retainer

3) Using the SST(09222-3K000, 09222-3C300), compress the springs and install the retainer locks. After installing the valves, ensure that the retainer locks are correctly in place before releasing the valve spring compressor.





4) Lightly tap the end of each valve stem two or three times with the wooden handle of a hammer to ensure proper seating of the valve and retainer lock.
2. Install IVILAs with engine oil applied on its surface.
Check that the MLA rotates smoothly by hand.





NOTE: MLA should be reinstalled in its original position.

3. Install OCV (Oil Control Valve)(A).





NOTE:
^ To install OCV with gray colored connector into RH bank.
^ To install OCV with black colored connector into LH bank.

CAUTION:
^ Do not reuse the OCV when dropped.
^ Keep clean the OCV
^ Do not hold the OCV sleeve during servicing.
^ When the OCV is installed on the engine, do not move the engine while holding the OCV yoke.
^ If there is dust on the Mter(B) of the OCV, clean it all.