Monitor Scantool Data
Monitor Scantool Data
1. Connect scantool to Data Link Connector (DLC).
2. Engine "ON".
3. Monitor the "PASSENGER AIR MID" Parameter on the Scantool. While operating passenger temp switch.
Fig 1) The current data in abnormal state
Fig 2) DTC B1204
4. Are the DTC B1204 present and is parameter of "PASSENGER AIR MID" fixed ?
NOTE:
** Parameter of "PASSENGER AIR MID" will be fixed at d at 100% (or any value above 90%), or 0% (or any value below 10%), if there is any fault in passenger air mix actuator.