Monitor Scantool Data

Monitor Scantool Data

1. Connect scantool to Data Link Connector (DLC).
2. Engine "ON".
3. Monitor the "DR DIRECTION POTENTIO" parameter on the scantool. While operating mode switch.




Fig 1) The current data in abnormal state
Fig 2) DTC B1250
4. Are the DTC B1250 present and is parameter of "DR DIRECTION POTENTIO" fixed ?

NOTE:
** Parameter of "DR DIRECTION POTENTIO" will be fixed at 100% (or any value above 90%), or 0% (or any value below 10%), if there is any fault in DR Direction actuator.