Monitor Scantool Data

Monitor Scantool Data

1. Connect scantool to Data Link Connector (DLC).
2. Engine "ON".
3. Monitor the "Intake potentiometer" Parameter on the Scantool. While operating Intake switch.




Fig 1) The current data in abnormal state
Fig 2) DTC B2408
4. Are the DTC B2408 present and is parameter of "Intake potentiometer" fixed ?

NOTE:
** There is any fault in Intake actuator. If the parameter of "Intake potentiometer" is 30% or less when the actuator operates to the FRE position, or If the parameter is 60% and more when the actuator operates to the REC position