Component Inspection

Component Inspection

1. OCV Inspection
(1) IG "OFF" & Disconnect OCV connector.
(2) Measure resistance between terminal 1 and 2 of OCV connector (Component Side)
Specification :









(3) Is the measured resistance within specification ?





2. Check CAM PHASER with actuation test
(1) Connect scantool and IG "ON"
(2) Select "CAM PHASER INTAKE BANK 2" on the Actuation Test
(3) Select "OIL CONTROL VALVE" on the Actuation Test
(4) Activates "CAM PHASER INTAKE BANK 2" by pressing "STRT (F1)" key
(5) Activates "OIL CONTROL VALVE" by pressing "STRT (F1)" key
(6) Repeat this procedure 4 or 5 times to ensure CAM PHASER and intake valve control solenoid reliability




(7) Has a problem been found ?