Component Inspection
Component Inspection
1. Check CMPS
(1) IG "OFF" and connect scantool.
(2) ENG "ON" and Measure signal waveform at terminal 3 of CMPS.
Reference signal waveform :
(3) Is the measured signal waveform normal ?
NOTE: There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by PCM. After testing PCM on the vehicle, use this function to reuse the PCM on the others
2. Check target wheel of CAM shaft
(1) IG "OFF"
(2) Remove the cover of cylinder head and check target wheel state of bank 2.
(3) Is the target wheel state normal ?