Component Inspection

Component Inspection

Check Solenoid Valve
1. Ignition "OFF"
2. Disconnect "A/T SOLENOID VALVE" connector
3. Measure resistance between terminal "5" and terminal "11" of the ATM SOLENOID VALVE harness connector.

Specification : Approximately 2.7 - 3.4 ohms (20 °C)





4. Is resistance within specifications ?





CHECK PCM/TCM
1. Connect scantool to data link connector (DLC)
2. Ignition "ON" & Engine "OFF".
3. elect A/T Solenoid valve Actuator test and Operate Actuator test.
4. Can you hear operating sound for LR SOLENOID VALVE Actuator Testing Function ?




Fig 1) ACTUATION TEST





ACTUATOR TEST CONDITION
1. IG SWITCH ON
2. TRANSAXLE RANGE SWITCH is normal
3. P RANGE
4. Vehicle Speed 0 km/h
5. Throttle position sensor < 1V
6. IDLE SWITCH ON
7. ENGINE RPM 0