Component Inspection

Component Inspection

1. Check resistance of ETS Motor
(1) IG "OFF"
(2) Disconnect ETS motor & TPS connector.
(3) Measure resistance between terminal 2 and 3 of ETS motor & TPS connector. (Component Side)

Specification : Approx. 1.275 - 1.725 ohms@ 23 °C (73.4 °F)





(4) Is the measured resistance within specifications ?





** Procedure of ETS Initialization
1. Erase the trouble codes on PCM
2. Turn the ignition key off and keep this condition until the main relay is turned off. (It will takes 10 sec.)
3. Turn ignition key on more than 1 second to record the throttle motor position on the EEPROM