Component Inspection
Component Inspection
1. Check TPS
(1) Ignition "ON" & ENG "OFF".
(2) Monitor signal waveform of TPS by stepping on and off the accelerator pedal on scantool
Specification :
Fig. 1) Pressing accelerator pedal at idle
Fig. 2) Pulling out accelerator cable with hand at idle
(3) Is the measured signal waveform O.K ?
** Procedure of ETS Initialization
1. Erase the trouble codes on PCM
2. Turn the ignition key off and keep this condition until the main relay is turned off. (It will takes 10 sec.)
3. Turn ignition key on more than 1 second to record the throttle motor position on the EEPROM