Monitor Scantool Data
Monitor Scantool Data
1. Connect scantool to Data Link Connector (DLC).
2. Engine "ON".
3. Monitor the "DR AIR MIX potentiometer" Parameter on the Scantool. While operating temp switch.
Fig 1) The current data in abnormal state
Fig 2) DTC B2406
4. Are the DTC B2406 present and is parameter of "DR AIR MIX potentiometer" fixed ?
NOTE:
** There is any fault in DR AIR MIX Motor. If the parameter of "DRIVER AIR MIX DOOR" is 30% or less when the actuator operates to the hot position, or If the parameter is 60% and more when the actuator operates to the cold position.