Monitor Scantool Data
Monitor Scantool Data
1. Connect scantool to Data Link Connector (DLC).
2. Warm up the engine to normal operating temperature.
3. Monitor DTC (Diagnostics Trouble Code) on the scantool.
FIG. 1) DTC B1201.
FIG. 2) The current data in normal state.
** Parameter of "Humidity Sensor" will be fixed at 10%, if there is any fault in Humidity Sensor
4. Is the same DTC displayed again ?
** Parameter of "Humidity Sensor" will be fixed at 10%, if there is any fault in Humidity Sensor
YES
1) Go to "Inspection/Repair" procedure.
NO
1) Fault is intermittent caused by poor contact in the sensor's and/or "A/C-ECM"s connector or was repaired and "A/C-ECM" memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure.