Component Inspection

Component Inspection

1. Check fork volt/detent switch
1. Ignition "ON" & engine "OFF" & PTG "ON"
2. Monitor 'Detent Switch','Forkbolt Primary Switch','Forkbolt Secondary Switch' parameter on the scantool while operating PTG.
A. Specification : Refer specification in Fig 3








Fig 2) current data at latch state










Fig 3) Output of 1st,2nd forkbolt/detent switch and operation of latch/cinch motor as a function of gate position
3. Is the measured current data within specifications ?
YES
1) Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
1) Substitute with a known-good Latch assembly and check for proper operation.
If the problem is corrected, replace latch assembly and then go to "Verification of Vehicle Repair" procedure.