W/Harness Inspection

Terminal and Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals.
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found ?
YES
1) Repair as necessary and go to "Verification Vehicle Repair" procedure.
NO
1) Go to "W/Harness Inspection" procedure.

Power Supply Circuit Inspection

1. Check for open in harness
1. Ignition "OFF" & engine "OFF"
2. Disconnect "PTG MOTOR" and "PTG module" connector.
3. Measure resistance between terminal of PTG and terminal of door motor.
A. Specification :Approx. 0 Ohms




4. Is the measured resistance within specifications ?
YES
1) Go to "Component Inspection" procedure.
NO
1) Check for open in power harness. Repair as necessary and go to "Verification of Vehicle Repair" procedure.