Component Inspection
Component Inspection
1. Check left APS
1. Ignition "OFF" & engine "OFF"
2. Disconnect APS
3. Measure resistance between both terminal of APS.
A. Specification : Anti pinch "ON" -> 500 Ohms, "OFF" -> 6.2 kOhms ± 5%
4. Is the measured resistance within specifications ?
YES
1) Go to "PTG module" procedure.
NO
1) Substitute with a known-good APS and check for proper operation.
If the problem is corrected, replace APS and then go to "Verification of Vehicle Repair" procedure.
2. Check PTG module
1. Ignition "ON" & engine "OFF"
2. Disconnect Left Pinch Strip module.
3. Measure the voltage between power terminal for APS of PTG module and chassis ground.
A. Specification :Approx. : above 0.7 - 3.66v
4. Is the measured resistance within specifications ?
YES
1) Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
1) Substitute with a known-good "PTG module" and check for proper operation. If the problem is corrected, replace "PTG module" and then go to "Verification of Vehicle Repair" procedure.