W/Harness Inspection
Terminal and Connector Inspection
1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check shorting connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found ?
YES
1) Repair as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
1) Go to "Telltale lamp Circuit Inspection" procedure.
Telltale lamp Circuit Inspection
1. Ignition "OFF".
2. Disconnect the battery (-) terminal cable from the battery and wait at least one minute.
3. Disconnect SRSCM main harness connector.
4. Connect the battery (-) terminal cable to the battery and Ignition "ON" & Engine "OFF".
5. Measure voltage between Telltale lamp terminal of the SRSCM harness connector and chassis ground.
A. Specification : Batt Voltage
6. Is the measured voltage within specifications ?
YES
1) Check telltale lamp and connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
1) Check airbag fuse, passenger compartment junction block, harness between junction block and SRSCM. Repair as necessary and go to "Verification of Vehicle Repair" procedure.