Monitor Scantool Data
Monitor Scantool Data
1. Connect 'TPMS exciter' or scantool to Data Link Connector (DLC).
2. Select "TPMS DIAGNOSIS" mode.
3. Select the "FULL" mode of "TPM DATA VALUES" function.
4. Monitor the parameters of 'Front Right WE sensor (S2)' on the 'TPMS exciter' or scantool.
Fig 1) Sensor current data (normal)
Fig 2) Sensor current data (failure)
Fig 3) Executing "SET SENSOR STATUS"
5. Are parameter normal ?
YES
1) Fault is intermittent. It has been repaired and TPMS receiver module memory is not cleared yet.
2) Go to "Verification of vehicle Repair" procedure.
NO
1) Replace Front Right WE sensor and register sensor ID with 'TPMS exciter'.
2) Go to "Verification of Vehicle Repair" procedure.