Monitor Scantool Data
Monitor Scantool Data
1. Connect 'TPMS exciter' or scantool to Data Link Connector (DLC).
2. Select "TPMS DIAGNOSIS" mode.
3. Select the "FULL" mode of "LFI STATUS" function.
4. Monitor the parameters of 'Rear Right LFI' on the 'TPMS exciter' or scantool.
A. Specification : 'RR NO RES.' is 'NO', 'RR FAIL P.' is 'NO', and 'RR PASS P.' is 'YES'.
Fig 1) Detect "PASS" pulse from LFI (normal)
Fig 2) Detect "FAIL" pulse from LFI (abnormal)
Fig 3) Executing "SET SENSOR STATUS"
5. Are parameters within specifications ?
YES
1) Fault is intermittent. It has been repaired and TPMS receiver module memory is not cleared yet.
2) Go to "Verification of vehicle Repair" procedure.
NO
1) Go to "Inspection/Repair" procedure.