Monitor Scantool Data
Monitor Scantool Data
1. Connect 'TPMS exciter' or scantool to Data Link Connector (DLC).
2. Select "TPMS DIAGNOSIS" mode.
3. Select the "FULL" mode of "SENSOR LEARN/LOCA. STATUS" function.
4. Monitor the parameter of four WE sensor's ID on the 'TPMS exciter' or scantool.
Fig 1) Normal registered Sensor ID
Fig 2) Executing "SET SENSOR STATUS"
5. Was ID of all sensor registered each ?
YES
1) Fault is intermittent. It has been repaired and TPMS receiver module memory is not cleared yet.
2) Go to "Verification of vehicle Repair" procedure.
NO
1) Check for vehicle interference sources.
2) Repair if necessary and then go to "Verification of Vehicle Repair" procedure.