Engine Control

Monitor DTC Status

1. Check DTC Status
(1) Connect scantool to Data Link Connector (DLC).
(2) IG "ON".
(3) Select "DTC" button, and then Press "DTC Status" to check DTC's information from the DTCs menu
(4) Read "DTC Status" parameter.








(5) Is parameter displayed "Present fault" ?
YES
1) Go to "System Inspection" procedure.
NO
1) Fault is intermittent caused by PCM memory was not cleared after repair. Erase DTC and drive the vehicle to satisfy the enable condition then, go to "System Inspection" procedure.