Component Inspection

Component Inspection

1. Check status
1. IGN "ON" & Engine "OFF" with key intended to register
2. Monitor the "KEY STATUS", "SMARTRA STATUS" and "ECU STATUS' Parameter on the Scantool.
A. Specification : 'LEARNT'




Fig 1) The current data in normal state
3. Are "KEY STATUS", "SMARTRA STATUS" and "ECU STATUS' Parameter within specifications ?
YES
1) Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
1) Go to "Check SMARTRA" procedure
2. Check SMARTRA
1. IGN "ON" & Engine "OFF"
2. Neutralize "SMARTRA" and Register transponder key by scantool.

NOTE: Pin code is required to Neutralize SMARTRA and to Register transponder key

3. Are Neutralizing and Registering completed normally ?
YES
1) Perform all the key teaching procedure with scantool. (All the keys must be retaught) and then, go to "Verification of Vehicle Repair" Procedure.

NOTE: Never change the password after SMARTRA is neutralized with scantool Otherwise, Virgin TP only possible to register.

NO
1) Substitute with a known-good SMARTRA and check for proper operation.
If the problem is corrected, replace SMARTRA and then go to "Verification of Vehicle Repair" procedure