Scantool Diagnostics
Monitor Scantool Data
1. Connect scan tool to data link connector (DLC)
2. Engine "ON".
3. Monitor the all solenoid-valve parameters on the scan tool
4. Shift gear at each position
FIG 1) P,N
FIG 2) "R"
FIG 3) "D 1st" gear
FIG 4) "2nd" gear
FIG 5) "3rd" gear
FIG 6) "4th" gear
FIG 7) "5th" gear
FIG 8) "6th" gear
5. Does all "SOLENOID DUTY" follow the referance data ?
YES
1) Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Throughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.Repair or replace as necessary and go to "Verification Vehicle Repair" procedure.
NO
1) Go to "Component inspection1" procedure.