Monitor DTC Status

Power Tail Gate

Power Tailgate - B2428 Right Pinch Strip Stuck Low - Monitor Scantool Data

Monitor Scantool Data

1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF" & PTG "ON"
3. Monitor the "Right Pinch Strip Voltage" Parameter on the Scantool.
A. Specification : 0.68 V or more








Fig 1) The current data in abnormal state
Fig 2) DTC B2428
4. Is the DTC B2428 present?
YES
1) Go to "Inspection & Repair" procedure.
NO
1) Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.