Monitor DTC Status

Tire Pressure Monitoring

Tire Pressure Monitoring System - C1340 RR LF Pulse Fail Detect - Monitor Scantool Data

Monitor Scantool Data

1. Connect 'TPMS exciter' or scantool to Data Link Connector (DLC).
2. Select "TPMS DIAGNOSIS" mode.
3. Select the "FULL" mode of "LFI STATUS" function.
4. Monitor the parameters of 'Rear Right LFI' on the 'TPMS exciter' or scantool.
A. Specification : 'RR NO RES.' is 'NO', 'RR FAIL P.' is 'NO', and 'RR PASS P.' is 'YES'.








Fig 1) Detect "PASS" pulse from LFI (normal)
Fig 2) Detect "FAIL" pulse from LFI (abnormal)
Fig 3) Executing "SET SENSOR STATUS"
5. Are parameters within specifications?
YES
1) Fault is intermittent. It has been repaired and TPMS receiver module memory is not cleared yet.
2) Go to "Verification of vehicle Repair" procedure.
NO
1) Go to "Inspection/Repair" procedure.