Monitor DTC Status

Tire Pressure Monitoring

Tire Pressure Monitoring System - C1351 FL LFI Open/Short - Monitor Scantool Data

Monitor Scantool Data

1. Connect 'TPMS exciter' or scantool to Data Link Connector (DLC).
2. Select "TPMS DIAGNOSIS" mode.
3. Select the "FULL" mode of "LFI STATUS" function.
4. Monitor the parameters of Front Left LFI on the 'TPMS exciter' or scantool.
A. Specification : 'FL NO RES.' is 'NO', 'FL FAIL P.' is 'NO', and 'FL PASS P.' is 'YES'.












Fig 1) Detect "PASS" pulse from LFI (normal)
Fig 2) Executing "SET SENSOR STATUS"
Fig 3) Open in Signal / Ground
Fig 4) Short to battery in Signal
Fig 5) Short to ground in Signal
5. Are parameters within specifications?
YES
1) Fault is intermittent. It has been repaired and TPMS receiver module memory is not cleared yet.
2) Go to "Verification of vehicle Repair" procedure.
NO
1) Go to "Inspection/Repair" procedure.