W/Harness Inspection

Engine

Engine Control - P0660 Intake Manifold Tuning Valve Control Circuit/Open (Bank 1) - W/Harness Inspection

Terminal and Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?
YES
> Repair as necessary and go to "Verification of Vehicle Repair" procedure
NO
> Go to "Power Circuit Inspection" procedure.

Power Supply Circuit Inspection

Check voltage
1. IG "OFF" and disconnect VIV connector.
2. IG "ON" and ENG "OFF"
3. Measure voltage between power terminal of VIV harness connector and chassis ground.
A. Specification : B+




4. Is the measured voltage within specification?
YES
> Go to "Control Circuit Inspection" procedure.
NO
> Check fuse connected to power of VIV for open or blown-off.
> Repair open or short to ground in harness, and go to "Verification of Vehicle Repair" procedure.

Control Circuit Inspection

Check short to ground in harness
1. IG "OFF" and disconnect VIV connector and PCM connector.
2. Measure resistance between control terminal of VIV harness connector and chassis ground.
A. Specification : Infinite




3. Is the measured voltage within specification?
YES
1) Go to "Check open in harness" as follows.
NO
1) Repair short to ground in harness, and go to " Verification of Vehicle Repair" procedure.
Check open in harness
1. IG "OFF" and disconnect VIV connector and PCM connector.
2. Measure resistance between control terminal of VIV harness connector and VIV control terminal of PCM harness connector.
A. Specification : Below 1 Ohms




3. Is the measured resistance within specification?
YES
1) Go to " Component Inspection" procedure.
NO
1) Repair open in harness, and go to "Verification of Vehicle Repair" procedure.