Seats: Service and Repair
Replacement
Seat Assembly Replacement
1. Remove the seat assembly mounting cover (A).
2. After loosening the seat assembly mounting bolts and nuts, remove the seat assembly (B).
3. Disconnect the connectors, and remove the seat assembly.
A. Disconnect the power seat connector (A), airbag connector, seat heater connector, seat belt buckle connector (B) and then remove the seat assembly.
A. Disconnect the power seat connector (A), airbag connector, seat heater connector, seat belt buckle connector (B) and then remove the seat assembly.
4. Installation is the reverse of removal.
CAUTION:
SEAT MOUNTING BOLT INSTALLATION PROCEDURE (manual seat only)
- Set the into the most rearward position.Check then each slide is locked, and then
Tighten the front mounting bolt temporarily.
- Set the seat into most forward position.Check that each slide is locked, and then
Tighten the rear mounting bolt completely.
- Set the seat into the most rearward position.
Check the front mounting bolt completely.
- Check that the seat operates to and fro smoothy and the locking portion locks properly.
NOTE:
- Use Hi-Scan tool to re-zero PODS system after replacing component. (Passenger's)