2009 12 21 and After
Detecting Condition
Inspection Procedures
Check for Continuity in the Diagnosis Line
1. Disconnect the connector from the ESC control module.
2. Check for continuity between terminals 30 of the ESC control module connector and 1 of the data link connector.
3. Is there continuity?
Check the Power Source of ESC Control Module
1. Disconnect the connector from the ESC control module.
2. Turn the ignition switch ON, measure the voltage between terminal 29 of the ESC control module harness side connector and body ground.
Specification :approximately B+
3. Is voltage within specification?
Check for Poor Ground
1. Check for continuity between terminal 5 of the data link connector and ground point.