Scantool Diagnostics

Transmission

Automatic Transaxle - P0713 Fluid Temp.Snsr.'A' Circ.-High (SHORT TO +B or OPEN) - Scantool Diagnostics

Monitor Scantool Data

1. Connect scan tool to data link connector (DLC)
2. Engine "ON".
3. Monitor the "OIL TEMPERATURE SENSOR" parameter on the scan tool
A. Specification : Increasing Gradually




FIG.1) Normal
4. Does "OIL TEMPERATURE SENSOR " follow the referance data?
YES
1) Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Throughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.Repair or replace as necessary and go to "Verification Vehicle Repair" procedure.
NO
1) Go to "W/Harness Inspection" procedure.