Sunroof / Moonroof: Adjustments

Adjustment

How To Initialize
1. Check that the glass has been installed.
A. Finished height adjustment.
2. Push the up switch. (Keep on pushing the switch)
A. the slide moved 5mm forward after 15 seconds.




3. After moving the slide 5mm forward, turn OFF the switch and push the UP switch (Keeping on pushing the switch with continuous operation)
A. If the operation above is normal condition, the sunroof once and closes.
4. When the sunroof is closed completely, turn OFF the UP switch initialize the motor completely.

When To Initialize The Motor
1. First operation the vehicle after manufacture it.
2. Initial value is erased or damaged because of short power electric discharge during operation
3. After using the manual handle.

Operating The Sunroof Emergency Handle
1. Use the sunroof emergency handle to close and open the sunroof manually for the following case only
A. To close the sunroof before driving a vehicle in a rainy day or on the highway if the sunroof cannot be closed due to failure of the sunroof motor or controller.
2. Operating method
A. Remove the overhead console.
B. Push the emergency handle up into the hexagonal drive (A) of the sunroof motor. You must push hard enough to disengage the motor clutch; other wise the emergency handle will slip due to incomplete fit in the motor.
C. Carefully turn the emergency handle clockwise to close the sunroof.
D. After closing the sunroof, wiggle the handle back and forth as you remove the tool from the motor to ensure the motor clutch reengages.
E. A 5mm hex socket may be used in place of them emergency handle, with a" Speeder" type handle.

CAUTION:
- Do not use power tools to operate the sunroof.
Damage to the components may occur.